IPSEC Zscaler Config based location-Juniper SSG5

Modified on Wed, 15 Jul, 2020 at 1:06 PM

1. Connect to SSID: IPSEC_Zscaler. Enter SSG Management IP address(192.168.50.1) inside web address bar. Login              credentials as follows;

    

    Admin Name: netscreen

    Password: root



2. After successfully login, Go to VPN>Autokey Advanced >Gateway. click Edit button.


3. On the gateway Edit Page, do the following:


a. IP Address/Hostname: Enter the ZEN VIP address for the primary gateway. In this example, it's 165.225.112.12. This ZEN VIP is tunneled to SG node. However if need to change other location then need to change the IP under this part.



4. Click Advanced



5. On the Advanced Gateway Edit Page, do the following;


    a. Preshared Key: Enter the pre-shared key for the VPN credentials you added in the Zscaler Admin Portal.

    b. Use As Seed: Leave unselected.

    c. Local ID: Enter the FQDN for the VPN credentials you added in the Zscaler Admin Portal. In this example, it's the FQDN         sg5@ask4key.com



6. Click Return



7. Click Ok to save Configuration




8. Go to VPN > Monitor Status to verify the tunnel connection. Wait for a few seconds for the configuration to be updated. If      the tunnel is running, then the SA Status will shown as Active and Link is Up



9. Verify the connection is going to right zscaler cloud as configured by typing ip.zscaler.com inside the browser.


Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article